Professional
skincare,
made easy.

HOW TO USE YOUR VEAUTY DOT

01. Prep

Clean your face with soap and water. Then you need to make sure you skin is in a wet/moisturised state in order to conduct the RF effectively. So apply the Aqualis Activator or a moisturiser, serum, cream or gel to the area you wish to treat.

02. Power

Turn on the VEAUTY Dot and choose one of the 3 energy levels. You should always start on the lowest setting to test your skins tolerability. Starting on the high setting when you're new can result in heat rash.

03. Press

Press/Stamp the device to skin ensuring all electrodes are in contact with skin. Every 2 seconds the device will vibrate, this is to let you know it is firing properly and working. Aim to hold the device to skin for 15 seconds or 30-60 seconds if you are experienced, which would be 15-30 vibrations. 
You should always release the device off skin when you feel the heat is too hot to handle. 
When you are starting out, you may not be able to hold the device to skin for 30 seconds, this is fine, listen to your skin.

04. Pro Tips

If you find the device is not staying on, it is likely due to your skin not being moisturised enough and too dry. Some serums can dry too quickly, so try a gel based skincare product or even a simple moisturiser and apply a good amount to the treatment area before starting.

You can revisit the same area within a session up to 3 times. More than this is not needed.

05. Cleaning

To clean the device, you only need to wipe down the contacts with a very damp towel and soap, or an alcohol wipe. You can remove the head off the device to do this but make sure water does not get underneath.